Hardware Manager- BoschDX4020

Bosch DX4020

DX4020 Connection - RPS

Flip the dip switches 1,2,3 to the down position. The remaining dip switches should be in the up position.
Power down the device.
Reapply power to the device.
From the command prompt type telnet xxx.xxx.xxx.xxx 9999 (where xxx.xxx.xxx.xxx is the IP address of the DX4020).
Enter 1 for channel and press the Enter key. The following properties should be modified.
Port = 7700
Connection Mode = CC
Datagram Type = 02
Enter 9 to save the changes
Install the RPS software and dongle drivers. The software version must be version 5.12 or greater in order to function with Symphony AC.
User Name = admin
Password = 1111
From the primary screen click on New and select D9412GV3.
Highlight the panel and click on View, Edit, Network.
Type the IP address and click OK.
Double mouse click on the panel and click on the Connection button.
Select Network from the drop down pick list and click Connect.
Connection should be established in a few seconds. With the panel connected, select GV2 AUX. Double mouse click on the SDI Automation and select Yes from the drop down pick list to enable SDI Automation.
Click Save and OK.
Click on Send and Receive.
Select Send to Panel.
Click Disconnect.

Setting the DX4020 Connection for Symphony AC

Flip dip switch seven (7) to the up position, all remaining dip switches should be in the down position.
Power down the device and reapply power after five (5) seconds.
From the command prompt type telnet xxx.xxx.xxx.xxx 9999 (where xxx.xxx.xxx.xxx is the IP address of the DX4020).
Enter 1 for chan3001
Connection Mode = C0
Accept the remaining defaults and enter nine (9) to Save and Exit.

NOTE: The firmware revision MUST be version 8.05 in order to function properly with Symphony AC and GV3 panels. Please contact Bosch for the firmware upgrade if necessary.

Symphony AC Operator Guide

[]